Blog /

Why we tell customers to stop using fabric softener

We get asked about laundry smells, slimy dispensers and dryers that won't dry all the time. A lot of the time, one product is part of the story: fabric softener. That includes the liquid kind and dryer sheets.

We're not saying it will wreck your machine overnight. But it leaves a waxy film behind, and that film builds up in places you can't see. Here's what we look for, and what you can do about it.

How fabric softener works

Softener works by coating fabric with a thin, slippery layer. That's what makes towels feel soft and cuts down on static.

The catch is that the coating doesn't only land on your clothes. It also lands on the inside of your washer and dryer. Over time, it adds up.

What it does inside your washer

  • Gunk in the dispenser. Softener can thicken and dry in the dispenser drawer or cup. It can clog the drawer so the softener doesn't flush out properly.
  • Slime on the drum and door seal. Softener residue mixes with leftover detergent and lint. On front-load washers, this often collects in the folds of the rubber door seal. That's a common cause of black spots and a musty smell.
  • Buildup where you can't reach. The same film can coat the outside of the inner tub and the drain area. Cold washes make it worse, because the residue doesn't rinse away as easily.

What it does inside your dryer

  • A clogged lint screen you can't see. Dryer sheets can leave a clear film on the lint screen. It can look clean but still block air. Try this: run a little water over your screen. If the water pools on top instead of going through, it's coated.
  • A coated moisture sensor. Many dryers have two metal strips inside the drum, usually near the lint screen. They sense when clothes are dry. When they get coated, the dryer can shut off too early or run too long. Check your owner's manual to see if your dryer has them and where they are.
  • Less airflow overall. A blocked screen plus lint in the vent means the dryer works harder and takes longer. If you missed our post on the second lint filter you've never seen, it's worth a read too.

What it does to your laundry

Softener can make towels less absorbent, because the coating sits on the fibres. Many workout clothes and some children's sleepwear say "no fabric softener" right on the care label. Always follow the label.

From our job list

We filmed the inside of a washer tub while we scraped off built-up fabric softener. It's the kind of buildup you never see until the washer is taken apart. You can watch it in the video below.

How to clean out the buildup

  1. Clean the dispenser. Pull out the drawer if it comes out (your owner's manual will show how). Soak it in warm, soapy water and scrub it with an old toothbrush. Wipe out the opening it slides into.
  2. Wipe the door seal (front-loaders). Gently pull back the folds of the rubber seal. Wipe them with a cloth and warm, soapy water, then dry it.
  3. Run a cleaning cycle. Many washers have a "clean washer" or "tub clean" setting. Use a washer cleaner made for your type of machine. Check your manual for what your brand recommends, and how often.
  4. Wash the dryer lint screen. Scrub it with warm, soapy water and a soft brush. Rinse it and let it dry completely before you put it back.
  5. Wipe the moisture sensor strips. Unplug the dryer first. Wipe the strips with a soft cloth and a little rubbing alcohol, or as your manual says.
  6. Leave the washer door open. After each load, leave the door or lid open so the drum can dry out.

What to use instead

  • Use less detergent. Too much soap leaves its own residue. Use the amount on the label, and HE detergent if your washer calls for it.
  • Try wool dryer balls. They help separate clothes as they tumble, which can cut drying time and help with softness.
  • Don't overdry. Overdrying makes clothes stiff and adds static. Take them out when they're just dry.
  • Be careful with home remedies. Some people use vinegar in the rinse. Some manufacturers advise against using it often, so check your owner's manual first.

When to stop and call a technician

Cleaning won't fix everything. Stop and call us if:

  • The washer still smells after a cleaning cycle and a good wipe-down.
  • The dispenser won't flush, even when it's clean.
  • Water is leaking or sitting in the drum after a cycle.
  • The dryer still shuts off early or runs too long after you clean the sensor strips.
  • You see scorch marks, smell burning, or the dryer feels much hotter than normal. Unplug it and don't use it until it's checked.

Watch the video

Need a hand?

X Appliance Inc. is a family-owned appliance repair business based in Haldimand County. If your washer smells or your dryer won't dry, we can take a look.

Call or text 905-531-7000 · Request service at xappliance.ca · Hours: Mon–Fri 9–7, Sat 9–4, Sun closed.